News

Does The Wifi Extender Would Affect The Speed Of Source Wifi?



Does a repeater affect the net speed of the source WiFi?

Of course, it will affect the total WIFI Link Internet speed. This is for sure. Users decide how much Internet speed is based on WIFI router, because the bandwidth of wired broadband applications is certain.

Basic cognition: the purpose of relay is to extend the distance and scope of the WIFI transmission of the original wireless router. When there is no real link to the Internet, will it affect the speed of the network? When the actual link occurs, the Internet will happen.

Extended cognition: the relay is to extend the distance of the WIFI, and there is nothing special about it.

After wireless relay, the network speed is slow and the bandwidth is reduced. How to solve it?

The root route signal is 3 lattices, the wireless direct Ping root route is 1-100ms, and the bandwidth 900k-1M is downloaded at full speed. After the relay route, the signal is 5 lattices (full), the Ping root route is 500-700ms, and the full speed download bandwidth is about 400k. Can you tell me how to solve this problem? Use the relay for use in a room with a poor signal. Expand the range of wireless networks, but this delay is so high that the bandwidth is shrinking.

How does this solve the root route signal 3, the wireless direct Ping root route 1-100ms? Use the relay for use in a room with a poor signal. Broadening the range of wireless networks, but the delay is so high.

After the relay route, the signal is 5 lattices (full), the Ping root route is 500-700ms, the full speed download bandwidth is about 400k, and the bandwidth 900k-1M is downloaded at full speed.

The problem of the speed of the wireless repeater

There are some places where the network is not covered, so two kinds of repeaters are bought. There are different phenomena. After the A relay, another new name network is formed, which can be searched at the same time, and the download speed is the same as that of the original network. And B after the relay, no new network, but the original network signal enhanced, but the speed of download only 30% to the original network -. This is the god horse situation. B relay, the new network does not appear, only the original signal network is enhanced, but the download speed is only 30% ~ 50% of the original network, like in the original network coverage where speed is slow, resulting in different phenomena: A relay after the formation of a new network (the name the original network and a new network can also search and download speed), the same.. with the original network home network in some places not covered, he bought two repeaters.

How does the speed of the network slow after WIFI repeater is relayed? How can we get faster

If the quality of signal transmission between two routers is good, only about half of the bandwidth can be used for data transmission.11 overhead, while the 2 routers are connected by network, which means that your bandwidth is actually divided into two halves. Although the range is more important than bandwidth, it is possible to run full speed. But this is the case.

After the wireless relay bandwidth is to halve, because the relay must be received and forwarded frames in the same channel, a charge relay, another is responsible for their communication with the computer, mobile phone, two routers will be closer to the distance, and the antenna must remain vertical with the ground. Between the two antennas, it is best to ensure a path of propagation with a sight distance.

(2) 2 wireless routing, but the transmission rate of the far distance client will be as low as 1Mbps. Because of 802, if the bridging bandwidth between the routers is relatively large. Because of the cause of the repeater, the bandwidth is divided in half again, it is more so when multiusers share the same channel, so you will encounter the problem of bandwidth.

The best solution:

It is the direct connection between the route and the relay with the network line. The loss of bandwidth is at the expense of wireless connections. Of course the reason for the slow network speed after wireless relay